Symptoms

On trying to open a product using Product Designer, the system reports the file needs to be

upgraded. Clicking OK to allow the upgrade, the system returns the following message:

Unable to open the file '...'. Check to make sure that the file is not in use and try again; (Code 30)"


Cause

This is caused when the Microsoft Jet database engine cannot open the required database file

(product file). There can be many different causes that relate to this message. Review the

resolutions below, trying each one until the problem is resolved.


Workaround

There is no known workaround at this time.


Resolution

Resolution 1

Verify you have write access to the folder where the product file is located.

  1. Click the Start button.
  2. Click My Computer.
  3. Navigate to the folder where the product file is located.
  4. From the File menu, click New, Text Document.
  5. Change the name of the file to "test file" and press Enter.

If you receive an error message at either step 4 or 5 then you probably don't have write access to

this folder. That is typically caused by either a network share that is setup for read-only access or

the user security on the server is configured for read-only access. Contact your systems

administartor to change the access to read/write.


Resolution 2

Verify that the file is not marked as read-only.

  1. Click the Start button.
  2. Click My Computer.
  3. Navigate to the folder where the product file is located.
  4. Select the product that cannot be opened.
  5. From the File menu, click Properties.
  6. On the General tab, verify the Read-only check box is unchecked.
  7. Click OK.


Resolution 3

Install the latest version of the Jet 4.0 Engine. The file to download and the installation instructions

are different for the various versions of Microsoft Windows. Refer to the following Microsoft document

for information on downloading and installing the latest version of Microsoft Jet 4.0:

http://support.microsoft.com/kb/829558


Resolution 4

Install the latest version of the Microsoft Data Access Compoents (MDAC). The file to download and

the installation instructions are different for the various versions of Microsoft Windows. Refer to the

following Microsoft document for information on downloading and installing the latest version of

MDAC:


http://www.microsoft.com/en-us/download/details.aspx?id=5793


The following article can be used for reference:

http://msdn.microsoft.com/en-us/library/ms810805.aspx


Note: MDAC is pre-installed on some versions of Windows and cannot be manually installed.


Applies To:

  • Product Designer 3.x
  • Product Designer 4.0
  • Product Designer 4.1
  • Product Designer 4.2
  • Solatech Window Covering Software, 3.x