Summary

This article explains how to use the Multi-Measurement feature in the Quick Entry screen of the

Solatech Window Covering Software.


More Information

The Multi-Measurement feature simplifies the measuring process when you need to take multiple

measurements and use the smallest (or largest). It allows you to take and send many measurements

and the software will find and use the correct measurement based on your settings.


Setup

While in Quick Entry, click the Options button and then click Other Settings. Once the options screen

is displayed click on the Advanced tab.


By default the multi-measurement feature will take three measurements. You can change the

number of measurements from 1 to 16.


Turn off after each measurement

In order to take multiple measurements the Enable multi-measurement mode check box must be

checked on the main Quick Entry form. Normally, this check box remains enabled so that you can

take multiple measurements for both width and height. If you want to take multiple

measurements on an infrequent bases you can check the box labeled Turn off after each

measurement. This will cause the multi-measurement mode to be disabled when you move from

one field to the next, for example from width to height.


Automatically determine smallest or largest measurement to use

If this is checked then the system will automatically determine if it should use the smallest or

largest of the multiple measurements based on what column, width or height, the cursor is on.

The system will use the smallest measurement for Width and the largest for Height. If you

uncheck this box then you will need to make sure you select the correct setting on the main Quick

Entry form before you take the last of your multiple measurements.


Using

Using the multi-measurement feature is simply a matter of taking multiple width or height

measurements, sending one at a time, just like you normally do. The only difference is that the

system will store the measurements and only apply the correct one once the last measurement has

been sent.

  1. Connect your Disto.
  2. Click in the Width field for the first row.
  3. Check the box Enable multi-measurement mode.
  4. Take the first measurement and send it to the computer. The measurement will display near the bottom of the screen.
  5. Take the next measurement and send it.
  6. Take the last measurement and send it. Once the last measurement is received the smallest or largest (based on your settings) will be put into the Width and the cursor will move to the height.


Note

  • Make sure the cursor is in the Width or Height columns when taking multiple-measurements. If not the final measurement may not get placed in the correct field.
  • Depending on your settings, the multi-measurement feature may be turned off each time you move from field to field. If you're taking multiple-measurements be sure to check the box to make sure it's enabled.
  • You can reset your multiple measurements by taking and sending a measurement larger than 300 inches. For example, if you take two of three measurements but need to restart, take a measurement of 300 inches or more and send it. Quick Entry will remove all existing multiple measurements and start over. To stop taking multiple measurements, uncheck the Enable multi-measurement mode check box. This feature only works if your Quick Entry units are set to inches.


APPLIES TO

  • Solatech Window Covering Software 4.2